Yet another update. You must be getting tired of them by now, surely.

[Note: while the file size is only 78 KB, the picture measures 4053x1641 pixels]
I'd originally planned to work on the sickbay layout, but when I needed to know the exact curving of the wall, it turned out that I needed to decide how high the decks are going to be. Problem is, I can't stick to Rick Sternbach's measurements, because my saucer is only 42 meters tall instead of the 54 meters given in the article. This means that I have to reduce the height of some decks. In the end, I needed to come up with five different values:
a) the dorsal sensor dome (tentatively called "A Deck")
b) the bridge level (B Deck) - I needed to lower the bridge onto the second level because the bridge dome isn't tall enough for it if I use the
Constitution layout. So the bridge is on B Deck, but this means that I can use the structure aft of the bridge dome as the top of the turboshaft.
c) upper and lower saucer levels (Decks C - F and K - N). The tallest I could make them is 3.2 meters, which is pretty good, I should think.
d) cargo/shuttlebays. SOME decks would definitely need to be reduced in height, and so I chose the cargo decks because I figured that most of the space there would be one large cavern-like space, as seen on the
Enterprise's cargo deck. The entire cargo bay would be three decks tall or so, even though the individual decks would only measure 2.788 meters high.
e) lower sensor dome (I Deck) - since it only incorporates sensor systems, it won't need to be as tall as a normal deck.
Comments/suggestions?