WIP USS Endeavour REFIT

Starting to work on the refit Endeavour, here's a rough-cut primary hull.

 

Good start Scott! I´ll be following this one.

 

That is a good saucer width.

 

Looks good so far

 

Just because I've been quiet doesn't mean I haven't been busy. Here is a screen-cap of my progress on the TMP Endeavour...

 

Here's a close-up of the preliminary work I've done on Endeavour's weapons hull:



...and these are the aft upper dorsal sensors:

 

Very nice so far

 

Wow, liking the amount of detail that is going into the sensor pallets.

 

Thanks, JES! When I'm doing these things, my attitude is "In for a penny, in for a pound." (see also anal-retentive, perfectionist)

 

I think I know what you mean. I also take pride into putting detail in my work too.

 

Unfortunately that means that it takes me forever to finish a project, and I'm *always* trying to improve it a bit more...

 

Hmmm...intriguing.

 

As the saying goes, "art is never finished, only abandoned".

 

So, you´re a perfeccionist? I know the feeling. I have a lot of unfinished wips cause I have the feeling it´s not perfect, at least, not the way I would like.

Keep working Scott, you doing a fine work.