View Single Post
Old November 2 2013, 02:01 PM   #8
Forbin's Avatar
Location: I said out, dammit!
Re: Kitbash Datasheets - some finished ones

danellis wrote: View Post

Do you have an aft-view of the Dominion? I couldn't figure out how the third nacelle attaches? (sorry if this has been covered in your orthos thread, or elsewhere).

Damn, didn't think of that. It's just on a pylon sticking straight up from the "manifold" hump. Maybe if we have some down time at work this week...

Bernard Guignard wrote: View Post
Forbin that is fantastic work these are screaming to be printed out in 11 x 17
It's hard to tell from the raster conversions, but most of them are proportioned for A2 and/or engineering C-cize (17x22). I started using those sizes when I had an Epson 1520 printer at home, which prints those sizes. Then it died, and the new models cost a freakin thousand dollars! Geez!!
Forbin is offline   Reply With Quote