View Single Post
Old September 12 2013, 04:24 PM   #195
Albertese's Avatar
Location: Portland, OR
Re: Scaling the Excelsior Filming Model

Maurice wrote: View Post
Guys over at the RPF have iIDed the primary component of the grabber as a kit part from a Tyrrell P34 six-wheeler. You can see the part here.
So, that fellow is scratchbuilding the Rebel Transport from The Empire Strikes Back. Are you saying that the same part was used on the Excelsior model, too? Could make sense, as the two movies were only a few years apart.

Check out my website:
Albertese is offline   Reply With Quote