View Single Post
Old August 28 2013, 04:41 AM   #284
SicOne
Commodore
 
Location: Omaha, NE
Re: Excelsior Technical Manual - Revived!

I had a couple of questions that were asked earlier, albeit in perhaps the incorrect thread, so here they are in the proper place.

Assuming the 467-meter length of the Excelsior, what are the dimensions of that underhull alcove? Is it really large enough, with enough "floor space", to serve as a shuttlebay? The curvature of the hull doesn't seem to give it a helluva lot of floor...unless they took a page from nuBSG's Pegasus and reverse the gravity plating to make the floor the ceiling.

Also, where is the Excelsior's main shuttlebay? I thought I saw a cutaway some time ago that showed the main shuttlebay to be in the primary hull, forward of the impulse engines but aft of the bridge. But looking at some of the images in this thread, I'm not so sure. I was always of the impression that the shuttlebay in the stern of the secondary hull was just for cargo shuttles only, and not the main shuttlebay.
SicOne is offline   Reply With Quote