View Single Post
Old August 27 2011, 10:27 PM   #468
blssdwlf
Commodore
 
Re: TOS Enterprise WIP

Yeah, it does. Although it could be because Reliant was shot from slightly below the saucer and the Enterprise slightly above.

@Everyone - I posted this in another thread in case I wasn't clear with my explanation...

I used the top of the bridge dome (the only circle in the middle) to calibrate against. Then I cross-checked with the profile view using the same dome and compared the radius of the saucers. Why the bridge? Because of all the things that might be scaled weirdly, I am assuming that the circle docking port present on the back of the Enterprise bridge would be the same size as the Reliant bridge and thus the two bridge tops should be very close in size or identical. Once that reference point is established, I can scale my 3D models appropriately

blssdwlf is offline   Reply With Quote