View Single Post
Old December 5 2010, 06:43 PM   #37
brandomack's Avatar
Location: Vancouver, BC
Re: My take on the NX refit (WIP)

The saucer will be attached using screws and an internal structure within the rear of the saucer with which to attach it to. I'm figuring that my setup will be more rigid than the original styrene.

plywood,balsa, brass, and epoxy. the pylons are supported from beneath, tied together across the keel with brass
following a "W" shape.
Dust! High fat, low fat? anyone? No? Dust!
brandomack is offline   Reply With Quote