View Single Post
Old March 4 2010, 06:50 PM   #348
CTM
Lieutenant Commander
 
CTM's Avatar
 
Location: The exact center of my universe
Re: WIP - TMP Enterprise, deck by deck

wjaspers wrote: View Post
CTM wrote: View Post
I rather like the TUC bridge from an actual operations standpoint, but I don't think it would fit in this "module" - this module is based on the TMP model - with two lifts in the rear. The TUC bridge would require the lifts approximately on the midline on the sides. I would build a specific bridge module for that particular design (and I may do just that).
All of the bridges, TMP, TVH, TFF, TUC, fit inside that module, no problems with the lifts.
No. They don't. Specifically, the ST VI: TUC bridge cannot fit. The others can, but with the lifts on either side, it would absolutely HAVE to add bulges on either side to fit the lifts. All the other bridges can fit, but that one cannot fit.
If you look here:
http://www.ex-astris-scientia.org/ga...e-a-bridge.jpg
and
http://www.ex-astris-scientia.org/ga...bridge-tvh.jpg
you can see the Turbo Lifts will not fit within this modeled exterior in the TUC version.
__________________
Building the impossible since 1992...
CTM is offline   Reply With Quote